spaceinvader Posted July 6, 2013 Report Share Posted July 6, 2013 I have installed debian on my hp medivault 5020. (http://www.cyrius.co...mv2120/install/)I have tried to use btsync on it. I have tried to install manually and I have tried install via apt-get (link).Both runs and gives med the webgui, but after a few seconds of file transfer it crashes.When I run it in --nodaemon I get the following error:"Segmentation fault"I have tried to search the net and the forums without luck.Any help would be much appriciated.Fyi: this is what the debian install page says about the compile environment: "You should now have a complete Debian system running on your HP mv2120. You can use apt-get and other tools to install additional software. The mv2120 is an ARM based device and the armel architecture is fully supported by Debian. " Quote Link to comment Share on other sites More sharing options...
jed Posted July 16, 2013 Report Share Posted July 16, 2013 Running into the same situation with my mediavault. Working fine to another ARM device but no go on the old mediavault. Not sure what to interpret from the logs to figure what the issue might be. Quote Link to comment Share on other sites More sharing options...
spaceinvader Posted July 20, 2013 Author Report Share Posted July 20, 2013 I just updated the btsync to the lastest version (Beta) - but same problem. it crashes after a while. Anybody please help Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.