Sync 2.0.52 Beta - Ui - Not Responding , High Cpu

[boruguru]

I installed 2.0.52, on windows 8.1 64 bit and added a share from a 1.4 with about 100k files, with Do not Sync-All option. After about 5 minutes, UI Reported Not-responding, and CPU was 100% for about 5 mins, and went back to normal. If that happen again, what type of information will be useful to collect to debug the issue? (Or this is normal behavior)

 

Now I see on the destination folder lot of .bts files. My expectation is if I click of them, it should sync the file. But nothing seems to happen.

 

What are my next steps? Should I wait longer (I waited 1 Hr - UI reports all in sync, file I am trying to bring over is small, all peers are local). Or should I restart / reboot?

[RomanZ]

@boruguru

Do I understand correctly that you've shared folder from 1.4 installation? If yes - which precise version? For the debugs - you can make couple of process dumps (use TaskManager for it) when Sync is not responding.

[boruguru]

If this happen again I will provide more information with a process dumps. So far that did not happen. May be it is a first time, when it start up with many files?

[Mike2700]

I just upgraded from 1.4.110 to 2.0.82 on Windows 7 x64. I have about 300Gb of data shared.  I think the 2.0 version is correct but i can't check because of the GUI problems below - its the one released today.

 

After the upgrade the UI for 2.0 is unresponsive and even reports Not Responding on occasion.  Somthing it happening in the GUI thread that need to happen in the background.  I guess an upgrade is going on, hopefully this will end shortly.  The GUI is not usable at this point.